Flying Cutoff & Punching Dies

Hill Engineering White Logo

Flying Cutoff & Punching Dies

Don’t let problems with your prenotch dies, flying post notch dies, flying cutoff dies and length measuring mechanisms hold down the speed and accuracy of your roll forming lines. With over 60 years experience in the roll forming and tubing industries, Hill Engineering is equipped to solve any of these problems. An increase in line speed and efficiency is an increase in profit.

Flying Postpunch Die

Flying Postpunch Die

which incorporates computer controlled “Gaging” of punches and piloting in order to create a variety of patterns without stopping the line

Flying cutoff End Punching

Flying Cutoff and End Punching Die

for shelving. Also offered is a line of slugless (single shear) dies for parts as small as automotive trim all the way up to 48″ wide roof deck panels.

Builds for all your needs

prepunch-die-roll-forming

Punching System with servo feed and computer controlled “Gaging” of punches in die to create the required patterns.

Steel Stud Punch Cutoff

High Speed Steel Stud Punching & Cutoff Systems. Both, air press and high speed hydraulic systems, with state-of-the-art electronic controls, are available.

Media

Aftermarket Support

Regardless of which Hill Engineering model or service, contract manufacturers can depend on Formtek for the aftermarket support, whether it is replacement parts, retrofits, or upgrades of existing equipment.

Need Help?
If you have questions about products Contact Us or Call Today 216.292.4460