Pittsburgh Lock Models 20 & 24
- Compact and light enough to be taken right to the job
- 20-28 gauge capacity
- Uses approximately 1" of material
- 5/16" Depth of pocket/size
- 30-75 fpm speed
Pittsburgh Lock Models 14, 16, & 18
These powerful performers offer the HVAC industry day-in/day-out service
- 7 forming stations with 2 forming positions
- 14-22 gauge capacity
- Uses approximately 1-3/8" to 1-1/8" of material
- 1/2" to 3/8" Depth of pocket/size
- 35 to 45 fpm speed
Button-Punch-Snap-Lock
Especially designed for commercial and industrial ductwork.
- 7 forming stations with 2 forming positions
- 14-22 gauge capacity
- Uses approximately 1-3/8" to 1-1/8" of material
- 1/2" to 3/8" Depth of pocket/size
- 35 to 45 fpm speed
Triplex Cleatformer
For reinforced "S" and drive cleats plus two optional auxiliary sheet-edge operations. Combination "S" and drive cleat scrap cutter attachment available.
- 22-28 gauge for "S" cleat operation
- 20-26 gauge for drive cleat operation
- "S" cleat width 1-1/16"
- Drive cleat width 1-1/8"
- 100 fpm speed
Standing "S" Cleat
In just one pass, form a shape that combines a conventional "S" cleat with standing seam for greater strength and rigidity.
- 20-26 gauge
- 1-1/8" pocket
- Uses 6-1/4" material stretch out inboard
- 60-70 fpm speed
TDC© V
This Roll former has 12 forming stations and produces TDC© flanges at speeds of up to 50 fpm
- 18-24 gauge for TDC©
- 22 gauge for Clip
- 1-7/8" TDC
- 2-1/8" Clip
Cornermatic®
Rapidly and automatically inserts and crimps corners into ductwork or fittings that use the TDC® method of joining. The machine requires only compressed air and 110-volt single phase current to operate. It may be used on the shop floor or the job site.
- Flange Type: TDC/F
- Gauge Range: 18 [.050"] to 26 [.022"] (1,27 mm to 0,56 mm)
- Cycle Time: Approx.:2 1/2 seconds per corner
Whisper-Loc®
- For closing longitudinal seams on rectangular duct.
- This machine is adjustable for duct made from 18" to 72" (457 to 1829 mm) coil width, and in gauges 26 to 18 (0.46 to 1.5 mm)
- It will accommodate duct with various end-joining methods such as raw, slip and drive, and most transverse flange systems
- This unit will also allow you to close Pittsburgh seams on straight edge fittings with a minimum length of 18 inches (457 mm)